Adaptation and Development of Silkworm (Bombyx mori L.) Strains in Kenya from Japanese Commercial F₁ Hybrids

Main Article Content

*Mary Guantai, Makoto Kiuchi, Tsunenori Kameda, Muo Kasina

Abstract

This study evaluated the adaptation and development of silkworm strains derived from Japanese Commercial F₁ hybrids under Kenyan rearing conditions, with emphasis on selection and stabilization rather than primary breeding from original parental lines. Sericulture in Kenya has been constrained by low cocoon productivity, limited availability of locally adapted strains, and strong environmental variability affecting silkworm performance and mulberry leaf quality. Two Japanese Commercial F₁ hybrids, Kinshu × Showa and Asahi × Tokai, were introduced and used as base populations to develop six silkworm lines (KSK1–KSK4 and ATK1–ATK2) through successive selection across multiple rearing cycles conducted between 2014 and 2019.


Cocoon productivity was evaluated using cocoon weight, shell weight, and shell ratio under uniform rearing and management conditions across all strains. Although substantial variability was observed during early rearing cycles, several derived strains exhibited progressive stabilization of productivity traits over successive cycles. Mean cocoon weights (1.62–1.77 g) and shell ratios (23.1–24.1%) of the adapted Japanese lines exceeded those of locally maintained ICIPE strains, which averaged approximately 1.40–1.46 g and 21%, respectively. Among the evaluated traits, shell ratio showed the most consistent stabilization, reflecting improved silk yield efficiency.


Comparative strain assessment indicated that KSK4 and ATK1 combined higher productivity with reduced within‑strain variability, distinguishing them from the other derived and local strains. Overall, the results demonstrate that Japanese Commercial F₁ hybrids can serve as effective starting material for adaptation‑based development of stable and productive silkworm strains under Kenyan sericulture conditions.